Garage Door Specialists
We Diagnose the Failure Before You Buy a New Opener
The opener hums and the door doesn't move. Or it grinds, travels slower than it used to, stops halfway, or simply goes quiet. Unusual noise and a door that has gotten sluggish are the early warning, and they are worth acting on — a failing motor tends to escalate from an annoyance into an emergency, usually on the morning you need to leave.
It is also a safety and security issue. A door that won't close leaves the garage open to anyone walking past, and a door that reverses unpredictably is a hazard around cars, kids, and pets. Catching the failure early keeps a small repair from becoming a stranded car and a wide-open garage.
The usual assumption is that the whole unit is finished, and that is the usual recommendation from anyone selling openers. Often it isn't necessary. Armour Overhead Doors is a family-run shop, and we bring the tools and the experience to find the actual failure — stripped gears, worn sprockets, failed capacitors, bad logic boards, and dead limit switches are all repairable, frequently for far less than a new opener and install. You get the diagnosis, both prices, and an honest read on which way the math points.
What We Repair
Opener Components We Repair
Stripped Drive Gears
The most common opener failure by a wide margin. The motor runs, you hear it clearly, and the door doesn't move. Gear and sprocket kits are an inexpensive repair on an otherwise healthy unit.
Worn Sprockets & Loose Chain
A slapping chain and a door that jerks on the way up. Left alone, this chews through gears and eventually strands the door.
Failed Capacitors
The opener hums but won't start, or starts only with a push. A capacitor is a small part and a short repair.
Bad Logic Boards
Erratic behavior, dead controls, remotes that stop pairing, lights that won't shut off. Boards are replaceable on most units without touching the rest of the opener.
Limit & Travel Switch Failures
The door stops short, slams into the floor, or reverses for no apparent reason. Sometimes it is adjustment, sometimes a failed switch.
Motor & Bearing Failure
Grinding, a burning smell, or a motor that won't turn over at all. This is the failure that usually does point toward replacement, and we will say so plainly rather than selling you a repair that won't hold.
Our Diagnostic Process
What We Look For During the Diagnostic Process
A straining motor is often a symptom rather than a cause. Worn rollers, dry hinges, and springs losing tension all force the opener to work far harder than it was built to, and correcting the door frequently fixes what looked like a motor problem. So we read the symptom first.
The motor runs but the door doesn't move
Almost always stripped gears or a broken trolley carriage. The opener itself is usually fine.
The opener hums & stalls
Typically a capacitor, though a badly unbalanced door or a broken spring produces the same symptom. Worth checking the door before condemning the motor.
The door reverses before closing
Sensor alignment, force setting, or an obstruction in the track. Rarely the motor at all.
Nothing happens at all
Power supply, wall console wiring, or logic board — in that order.
It works from the wall but not the remote
Remote batteries, programming, or the receiver on the board. One of the cheaper calls we run.
Repair or Replace
How to Decide Between Repair & Replacement
Benefits of Repair
Costs a fraction of a new opener and install. On a unit under roughly ten to fifteen years old with a sound housing and rail, a gear kit, capacitor, or board brings it back to full function. It also takes load off the rest of the system, since a struggling opener works the door harder every time it runs.
Benefits of Replacement
A new unit comes with a fresh warranty, current safety sensors, quieter operation, and an end to one-off repair bills. It's the better value when the motor itself has failed, when parts are discontinued for the model, or when repair costs are approaching the price of a new opener.
What to Expect
Our Motor Repair Process
01.
Tell us what it's doing.
Call or text the symptom — humming, grinding, silence, partial travel. A short video of the opener running tells us more than a description usually can.
02.
We diagnose the whole system.
Opener, springs, balance, rollers, and track. We're looking for the cause, not just the part that stopped working.
03.
We price both options.
Repair cost and replacement cost side by side, with an honest read on how much life the repair buys you. Nothing gets done until you say go.
04.
We fix it & test it.
Parts replaced, travel and force settings reset, safety reverse tested, and a walkthrough of what changed before we leave.
Common Concerns
Frequently Asked Questions
How do I know if it's the motor or the door?
Pull the manual release and lift the door by hand. If it's heavy, sticks, or won't stay put halfway, the problem is the door — and the opener has been compensating for it. If it glides easily and holds position, the opener is the suspect.
Can a failing opener be a security risk?
Yes. An opener that won't close the door, or that reverses on its own after you've driven away, leaves the garage open and everything in it accessible. It's one of the reasons we'd rather look at it sooner than later.
Do you carry parts for older openers?
We carry the common gear kits, capacitors, and hardware on the truck. Boards and model-specific parts sometimes need to be ordered, and for discontinued units we'll tell you plainly if parts are no longer available.
Is it worth repairing an opener without safety sensors?
Generally no. Openers that old predate current safety requirements, and replacement is the better call for any household with kids or pets.
Can you repair commercial operators?
Yes. We service commercial and warehouse operators alongside residential units.
Do you charge for the diagnosis?
Estimates are free and there's no obligation.
What are your hours?
Monday through Friday, 7:30 AM to 4:00 PM. We also run a 24-hour emergency line for doors that fail outside those hours.
